Giriş

This is a guide on how to replace the logic board on your Blackberry 7510.

Parçalar

Hiçbir parçaya gerek yok.

  1. Remove the battery cover and battery before continuing.
    • Remove the battery cover and battery before continuing.

    • Remove the six T6 Torx screws on the back of the phone.

    • Make sure to keep the screws somewhere that they will not get lost.

    Yorum Ekle

  2. Using your finger nail or a spudger, carefully pry up the back cover.
    • Using your finger nail or a spudger, carefully pry up the back cover.

    • Begin in one spot and slowly circle around the device as you pry up all of the back cover.

    Yorum Ekle

    • Lift off the back cover.

    Yorum Ekle

    • Remove the two T6 screws.

    Yorum Ekle

    • Remove the daughterboard.

    • Remove the exposed vibration motor.

    Yorum Ekle

    • Using the T6 Torx screwdriver, remove the top screw.

    Yorum Ekle

    • Using your spudger, carefully pry off back plate.

    • Use the same technique as with the plastic back cover. Circle around the back plate until all of it is pried up.

    Yorum Ekle

    • Remove the front cover and keypad.

    Yorum Ekle

    • Remove one T6 Torx screw in the front bottom right of the board.

    Yorum Ekle

    • Carefully pry the screen from the board with your spudger.

    • After prying it up, remove the screen from the board.

    Yorum Ekle

    • Unscrew center T6 Torx screw in the center of the logic board.

    • Remove the logic board from the phone.

    • Replace with new logic board.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Neil Johnson

Üyelik tarihi: 24-01-2010

12 İtibar

6 adet Kılavuz yazıldı

Takım

Cal Poly, Team 14-44, Regan Winter 2010 Cal Poly, Team 14-44, Regan Winter 2010 üyesi

CPSU-REGAN-W10S14G44

4 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 2

Her zaman: 1,783