Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

Giriş

Use this guide to replace the front facing camera of the Blu Studio Selfie.

  1. Make sure your phone is powered off.
    • Make sure your phone is powered off.

    • Turn the front of the phone away from you.

    • Run your fingers along the sides of the phone to identify where the case can be pulled apart.

  2. Insert the flat end of your plastic opening into the crevice you found along the side of the phone.
    • Insert the flat end of your plastic opening into the crevice you found along the side of the phone.

    • Gently apply pressure until you feel the back case pop free of the phone.

    • Continue the previous two steps around the rest of the phone until the case is fully removed.

  3. Identify the crevice at the bottom of the battery. There should be enough space for you to fit your fingernail between the battery and the phone.
    • Identify the crevice at the bottom of the battery.

    • There should be enough space for you to fit your fingernail between the battery and the phone.

    • Gently lift the battery free of the phone.

  4. Manta Tornavida Seti

    112 bits for every fix.

    Upgrade Your Toolbox

    Manta Tornavida Seti

    Upgrade Your Toolbox
  5. Remove all the 4mm Phillips #000 screws from the midframe.
    • Remove all the 4mm Phillips #000 screws from the midframe.

  6. Insert the spudger between the midframe and the display assembly.
    • Insert the spudger between the midframe and the display assembly.

    • Gently pry up the midframe.

    • When working with electronics, it's important to choose a tool that's ESD-safe to avoid accidental damage to the device. The metal spudger is great when you need serious prying power, but the regular black nylon spudger or a plastic opening tool should be used whenever possible.

  7. Where the battery rested before, you will find a small clip that holds down the midframe.
    • Where the battery rested before, you will find a small clip that holds down the midframe.

    • After the rest of the midframe is detached, from the phone place the flat end of the spudger beneath the clip.

    • Gently lift up on the clip until it comes free.

    • Remove the midframe from the phone.

  8. Use tweezers to  lift the black tab on the ZIF connector and pull the ribbon cable out of place. Using  a pair of tweezers for assistance, remove the front facing camera from its case. Using  a pair of tweezers for assistance, remove the front facing camera from its case.
    • Use tweezers to lift the black tab on the ZIF connector and pull the ribbon cable out of place.

    • Using a pair of tweezers for assistance, remove the front facing camera from its case.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Stacy Kam

Üyelik tarihi: 20-01-2016

618 İtibar

5 adet Kılavuz yazıldı

Takım

USF Tampa, Team 10-1, Remmell Spring 2016 USF Tampa, Team 10-1, Remmell Spring 2016 üyesi

USFT-REMMELL-S16S10G1

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 1

Son 30 gün: 1

Her zaman: 363