Ana içeriğe geç

Parçalar

Hiçbir parça belirtilmedi.

  1. To remove the outer rubber casing use a 3mm Hex bit to remove the 4 large 12mm Hex screws on both sides, found on the bottom part of the device.
    • To remove the outer rubber casing use a 3mm Hex bit to remove the 4 large 12mm Hex screws on both sides, found on the bottom part of the device.

  2. Using the Metal Spudger, carefully pry each side of the rubber casing away from the device.
    • Using the Metal Spudger, carefully pry each side of the rubber casing away from the device.

    • A little resistance should be felt, but not enough to bend the spudger.

  3. Apple Watch Kitleri

    Screen and battery repairs just got easier.

    Hemen Alışveriş Yapın

    Apple Watch Kitleri

    Screen and battery repairs just got easier.

    Hemen Alışveriş Yapın
  4. To remove the hard inner plastic casing, use a Phillips #00 head bit to remove the 16 small 9mm screws surrounding the subwoofer on the top side of the device.
    • To remove the hard inner plastic casing, use a Phillips #00 head bit to remove the 16 small 9mm screws surrounding the subwoofer on the top side of the device.

  5. Carefully lift away the broken sub-woofer plate of the device. Replace with functioning sub-woofer plate.
    • Carefully lift away the broken sub-woofer plate of the device. Replace with functioning sub-woofer plate.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Erik Oliva

Üyelik tarihi: 14-02-2018

607 İtibar

6 adet Kılavuz yazıldı

Takım

USF Tampa, Team S2-G1, Eyestone Spring 2018 USF Tampa, Team S2-G1, Eyestone Spring 2018 üyesi

USFT-EYESTONE-S18S2G1

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 2

Her zaman: 39