Ana içeriğe geç

Parçalar

Hiçbir parça belirtilmedi.

  1. Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.
    • Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.

  2. Remove batteries, cassette tape, and cutter blade.
    • Remove batteries, cassette tape, and cutter blade.

  3. Use a phillips size #00 screwdriver to unscrew the 5 corner screws circled in the picture.
    • Use a phillips size #00 screwdriver to unscrew the 5 corner screws circled in the picture.

  4. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  5. Separate the top of the device from the bottom. Be very cautious when you separate the device, there is a ribbon attaching the top to the bottom.
    • Separate the top of the device from the bottom. Be very cautious when you separate the device, there is a ribbon attaching the top to the bottom.

  6. Remove the two black side panels. They will easily fall out so just move them to the side until you are putting your device back together.
    • Remove the two black side panels. They will easily fall out so just move them to the side until you are putting your device back together.

  7. Using your index finger and thumb, pull out the golden ribbon from the green circuit board. Using your index finger and thumb, pull out the golden ribbon from the green circuit board. Using your index finger and thumb, pull out the golden ribbon from the green circuit board.
    • Using your index finger and thumb, pull out the golden ribbon from the green circuit board.

  8. Use a phillips size #00 screwdriver to remove the two screws, circled in red, from the green circuit board.
    • Use a phillips size #00 screwdriver to remove the two screws, circled in red, from the green circuit board.

  9. Carefully remove the green circuit board by pulling it straight up. Be careful not to break the LCD cable ribbon that connects the circuit board to the device.
    • Carefully remove the green circuit board by pulling it straight up. Be careful not to break the LCD cable ribbon that connects the circuit board to the device.

    • The ribbon is very fragile so be careful to break it when pulling up on the circuit board.

  10. Underneath the circuit board you will find the rubber keyboard. Peel this off and remove it from the device. Underneath the circuit board you will find the rubber keyboard. Peel this off and remove it from the device. Underneath the circuit board you will find the rubber keyboard. Peel this off and remove it from the device.
    • Underneath the circuit board you will find the rubber keyboard. Peel this off and remove it from the device.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Haley Sweet

Üyelik tarihi: 30-10-2014

452 İtibar

4 adet Kılavuz yazıldı

Takım

Baylor, Team 4-4, Williams Fall 2014 Baylor, Team 4-4, Williams Fall 2014 üyesi

BU-WILLIAMS-F14S4G4

4 Üyeler

4 adet Kılavuz yazıldı

Bir Yorum

Hi!

Thanks for this very helpful and detailed set of instructions. One small suggestion - assuming that replacing the keyboard means you need a working one to replace the old one with, you might want to consider adding “Parts: replacement keyboard” instead of “No parts required.”

Cheers,

Maria B

Maria Bitterli - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 4

Son 30 Gün: 16

Her zaman: 1,118