Giriş

In order to switch the stitching styles of your sewing machine, the stitch select knob must be properly functioning. This guide will show the steps for replacement.

Parçalar

Hiçbir parçaya gerek yok.

  1. Place the machine on a solid surface.
    • Place the machine on a solid surface.

    • Remove the 14mm Phillips #2 screw holding on the face cover.

    Yorum Ekle

  2. Remove the two 14mm Phillips #2 screws and two 22mm Phillips #2 screws that secure the rear casing.
    • Remove the two 14mm Phillips #2 screws and two 22mm Phillips #2 screws that secure the rear casing.

    Yorum Ekle

    • Lay the machine on its side.

    • Remove the four 10mm Phillips #2 screws that hold the bottom panel in place.

    • The feet will come off with the screws.

    Yorum Ekle

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • Remove the bottom panel.

    Yorum Ekle

    • Place the machine upright.

    • Remove the rear casing.

    • You may have to wiggle the panel and pull at the same time.

    Yorum Ekle

    • Adjust the knob to gain access to the phillips head screw.

    Yorum Ekle

    • Remove the 14mm Phillips #2 screw.

    Yorum Ekle

    • Remove the knob.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Kevin Bickers

Üyelik tarihi: 05-02-2014

601 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 2-12, Amido Winter 2014 Cal Poly, Team 2-12, Amido Winter 2014 üyesi

CPSU-AMIDO-W14S2G12

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 4

Her zaman: 492