Giriş

This guide teaches how to to install the back panel latch on your camera.

  1. Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
    • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

    Yorum Ekle

  2. Using your finger, peel back the textured grip so the components are separated.
    • Using your finger, peel back the textured grip so the components are separated.

    Yorum Ekle

  3. Free shipping on orders over $20
    Use code BLUEANDBLACK at checkout
    Free shipping on orders over $20
    Use code BLUEANDBLACK
    • Using the flat end of a spudger, loosen the connection between the front panel and the device.

    • Remove the front panel using your hands.

    Yorum Ekle

    • Using a 00 Phillips screw driver, unscrew the two screws located on the side of the camera.

      • Two 4.3 mm Phillips screws

    Yorum Ekle

    • Open the back panel by pushing the locking latch up.

    • Lift the latch cover off of the camera body.

    Yorum Ekle

    • Slide the side latch (for the back door) up and then lift straight away from the camera body.

    • Sometimes the latch will detach while pushing it up.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Zach

Üyelik tarihi: 04-04-2012

40 İtibar

8 adet Kılavuz yazıldı

Takım

Cal Poly, Team 14-9, Forte Spring 2012 Cal Poly, Team 14-9, Forte Spring 2012 üyesi

CPSU-FORTE-S12S14G9

5 Üyeler

12 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 7

Her zaman: 1,728