Giriş
This guide will instruct you how to install the flash on your camera.
Neye ihtiyacın var
-
-
-
Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
FixBot'a Sor
-
-
-
Using your finger, peel back the textured grip so the components are separated.
-
-
-
Using the flat end of a spudger, loosen the connection between the front panel and the device.
-
Remove the front panel using your hands.
-
-
-
-
-
-
Remove the flash cover to access the flash bulb.
-
After wires are unsoldered, slide flash bulb out from housing.
-
To reassemble your device, follow these instructions in reverse order.
İptal et: Bu kılavuzu tamamlamadım.
Bir başkası bu kılavuzu tamamladı.
Ekip
Cal Poly, Team 14-9, Forte Spring 2012 Cal Poly, Team 14-9, Forte Spring 2012 üyesi
CPSU-FORTE-S12S14G9
5 Üyeler
36 adet Kılavuz yazıldı
