Giriş

This guide shows you how to install a new lens connector.

Parçalar

Hiçbir parçaya gerek yok.

Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
  • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

Yorum Ekle

Using your finger, peel back the textured grip so the components are separated. Using your finger, peel back the textured grip so the components are separated.
  • Using your finger, peel back the textured grip so the components are separated.

Yorum Ekle

Using the flat end of a spudger, loosen the connection between the front panel and the device. Remove the front panel using your hands. Remove the front panel using your hands.
  • Using the flat end of a spudger, loosen the connection between the front panel and the device.

  • Remove the front panel using your hands.

Yorum Ekle

Using a Phillips #00 screwdriver, remove the 5 indicated screws
  • Using a Phillips #00 screwdriver, remove the 5 indicated screws

    • Five 6.2 mm Phillips screws

Yorum Ekle

Using your hands, remove the top black ring.
  • Using your hands, remove the top black ring.

  • WARNING! The indicated piece is spring loaded. Prepare for it to eject when taking off top ring.

    • Spring located here.

Yorum Ekle

There are two silver metal rings. Remove the top silver metal ring.
  • There are two silver metal rings.

  • Remove the top silver metal ring.

Yorum Ekle

Remove the bottom silver ring.
  • Remove the bottom silver ring.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

Zach

Üyelik tarihi: 04-04-2012

40 İtibar

8 adet Kılavuz yazıldı

Takım

Cal Poly, Team 14-9, Forte Spring 2012 Cal Poly, Team 14-9, Forte Spring 2012 üyesi

CPSU-FORTE-S12S14G9

5 Üyeler

12 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 2

Son 30 Gün: 5

Her zaman: 1,381