Giriş

This guide will teach you how to replace a faulty speaker.

Parçalar

Lift the printer lid up as shown in the photo.
  • Lift the printer lid up as shown in the photo.

Yorum Ekle

Locate and remove the two 10mm side screws. There is one on each side.
  • Locate and remove the two 10mm side screws. There is one on each side.

Yorum Ekle

  • Unhook the plastic panel from the printer starting from the top.

    • You may need to wiggle the panel a bit to loosen it.

  • To remove the bottom part of the paneling gently lay the printer on its back.

    • The scanner lid needs to be supported when moving the printer

Yorum Ekle

  • Gently unhook the right side paneling (as looking at the printer's front face) from the printer.

    • Use a gentle back and forth motion to wiggle the hooks out.

Yorum Ekle

  • Lay printer on its left side for better access to the speaker.

    • Note: The scanner lid needs to be supported when moving the printer

Yorum Ekle

  • Locate the black 7mm screw holding the speaker in place.

  • Using a Phillips head screw driver, unscrew the 7mm screw.

Yorum Ekle

  • Locate the red and black wires connected to the speaker.

  • Undo the white clip holding the wires in place by pinching the tab on the top.

  • Remove the red and black wires from the wire bundle.

  • When replacing the old speaker, do not touch any part of the new speaker that is not metal other than the wires. Doing so could damage the speaker.

  • Lift out the speaker

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Helena Yanez

Üyelik tarihi: 29-09-2013

446 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 13-1, Forte Fall 2013 Cal Poly, Team 13-1, Forte Fall 2013 üyesi

CPSU-FORTE-F13S13G1

5 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 16

Her zaman: 938