Giriş

Use this guide to replace the Canon Powershot A75's casing.

Parçalar

Hiçbir parçaya gerek yok.

Turn the camera over and locate the "BATT OPEN" sliding switch.
  • Turn the camera over and locate the "BATT OPEN" sliding switch.

Yorum Ekle

Slide the switch to the right. The battery cover should slide down and spring open. The battery cover should slide down and spring open.
  • Slide the switch to the right.

    • The battery cover should slide down and spring open.

Yorum Ekle

Remove the 4 AA batteries. Watch for the orientation of the batteries as they slide out. The battery orientation is shown under the battery flap itself and on a sticker next to the battery flap.
  • Remove the 4 AA batteries.

    • Watch for the orientation of the batteries as they slide out.

    • The battery orientation is shown under the battery flap itself and on a sticker next to the battery flap.

Yorum Ekle

Remove the three 2.5mm screws on the bottom of the camera.
  • Remove the three 2.5mm screws on the bottom of the camera.

Yorum Ekle

Remove the 3.8mm screw underneath the flap that covers the A/V port.
  • Remove the 3.8mm screw underneath the flap that covers the A/V port.

Yorum Ekle

Remove the 2.4mm screw located underneath the cover of the memory card slot. Remove the 2.4mm screw located underneath the cover of the memory card slot.
  • Remove the 2.4mm screw located underneath the cover of the memory card slot.

Yorum Ekle

Open the memory card slot by sliding it laterally until you hear a click. Remove the 5.9mm screw in the upper corner of the memory card slot.
  • Open the memory card slot by sliding it laterally until you hear a click.

  • Remove the 5.9mm screw in the upper corner of the memory card slot.

Yorum Ekle

Remove the two 4.1mm screws at the bottom of the battery flap.
  • Remove the two 4.1mm screws at the bottom of the battery flap.

Yorum Ekle

Lift the shutter button and speaker part from the top of the camera. DO NOT pull the part too hard because there is a plug connecting the speaker to the camera.
  • Lift the shutter button and speaker part from the top of the camera.

    • DO NOT pull the part too hard because there is a plug connecting the speaker to the camera.

Yorum Ekle

Using a pair of tweezers, grab the plug that connects the speaker to the camera and gently pull it out. Using a pair of tweezers, grab the plug that connects the speaker to the camera and gently pull it out. Using a pair of tweezers, grab the plug that connects the speaker to the camera and gently pull it out.
  • Using a pair of tweezers, grab the plug that connects the speaker to the camera and gently pull it out.

Yorum Ekle

Remove the rightmost 4.2mm screw underneath the battery cover, not the center screw.
  • Remove the rightmost 4.2mm screw underneath the battery cover, not the center screw.

Yorum Ekle

Separate the back casing and front casing of the camera using your hands. Pulling the two halves apart can be difficult, especially at the top. Use a moderate amount of force. Pulling the two halves apart can be difficult, especially at the top. Use a moderate amount of force.
  • Separate the back casing and front casing of the camera using your hands.

    • Pulling the two halves apart can be difficult, especially at the top. Use a moderate amount of force.

Yorum Ekle

On the front of the camera, press the button on the lower left of the lens. Twist the outer lens casing counter-clockwise and slide it out. Twist the outer lens casing counter-clockwise and slide it out.
  • On the front of the camera, press the button on the lower left of the lens.

  • Twist the outer lens casing counter-clockwise and slide it out.

Yorum Ekle

Take off the front casing. There is a black rubber washer around the lens that comes out after you take the casing off. Make sure to replace it when putting the camera back together. There is a black rubber washer around the lens that comes out after you take the casing off. Make sure to replace it when putting the camera back together.
  • Take off the front casing.

  • There is a black rubber washer around the lens that comes out after you take the casing off. Make sure to replace it when putting the camera back together.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

4 başka kişi bu kılavuzu tamamladı.

Andrew Elliott

Üyelik tarihi: 12-04-2012

13 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team 17-30, Amido Spring 2012 Cal Poly, Team 17-30, Amido Spring 2012 üyesi

CPSU-AMIDO-S12S17G30

5 Üyeler

6 adet Kılavuz yazıldı

Bir Yorum

Thank you for this detailed guide. It helped me to gain access to the electrical contacts in the battery compartment to remove alkaline battery corrosion

Jef B - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 3

Son 30 Gün: 5

Her zaman: 785