Giriş

This guide will allow you to repair or replace the viewfinder of the Canon PowerShot A95.

  1. Locate the black “BATT OPEN” button on the underside of the camera.
    • Locate the black “BATT OPEN” button on the underside of the camera.

    • Slide the black “BATT OPEN” button to the right.

    • Remove four AA batteries from the device.

    Yorum Ekle

  2. Locate and remove three screws on the underside of the camera (3x small Phillips head).
    • Locate and remove three screws on the underside of the camera (3x small Phillips head).

    • Keep all screws separated by step and in a place where they will not be lost.

    • Tip: a jewelry tray can be helpful for keeping all the screws secure and separated.

    Yorum Ekle

    • Locate and remove two screws on the same side of the camera as the marked A/V port (2x small Phillips head).

    Yorum Ekle

    • Using the blue plastic opening tool, remove the plastic covering you just removed screws from on the left side of camera.

    • Gently pull up around edges until the plastic flap inside is pulled out and the piece swings upward (piece should pull free).

    Yorum Ekle

    • Remove indicated screw holding front of camera in place.

    Yorum Ekle

    • Push against the memory card cover in order to pull it outward toward you to reveal a screw underneath.

    • Remove this screw (Phillips head).

    Yorum Ekle

    • Re-open the battery cover. Locate and remove the three screws under the battery cover (3x small, long Phillips head).

    • Tip: using a magnetic screwdriver is very helpful, as the screws are difficult to reach.

    Yorum Ekle

    • Locate and lift the shutter button, speaker, and option wheel from the top of the camera.

    • Note: DO NOT pull too hard as there is a plug connecting the speaker to the camera.

    • The memory card cover will pop off in this process.

    • Note the original location next to the loose pieces of hardware. This piece will remain attached to the device, so do not try to fully detach it.

    Yorum Ekle

    • Locate and press the button on the lower left corner of the lens.

    • Separate the back casing from the front casing of the camera.

    • Removing the casing may require the use of a spudger.

    Yorum Ekle

    • Twist the LCD screen so it is perpendicular to the camera and snap the back casing off.

    • This piece will remain attached to the device, so do not try to fully detach it.

    Yorum Ekle

    • Carefully jiggle the viewfinder until it comes loose from the camera.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Elizabeth Kisner

Üyelik tarihi: 24-09-2013

101 İtibar

1 Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 11

Her zaman: 1,129