Giriş

This guide illustrates how to replace the LCD screen on the Canon PowerShot S400.

Parçalar

Hiçbir parçaya gerek yok.

Unless stated otherwise, use a Phillips #00 screwdriver to remove all screws.
  • Unless stated otherwise, use a Phillips #00 screwdriver to remove all screws.

  • On the backside of the camera, remove the 4.75 mm screw that sits at the top right corner.

  • Remove the four 4.75 mm screws that sit at the bottom of the camera.

Yorum Ekle

On the side of the camera, remove the two 4.75 mm screws that sit near the USB digital terminal.
  • On the side of the camera, remove the two 4.75 mm screws that sit near the USB digital terminal.

Yorum Ekle

  • On the side of the camera, remove the four 4.75 mm screws that sit near the wrist strap mount.

  • Remove the two small metal plates, which the four screws held in place.

Remove the two small metal plates, which the four screws hold in place.

Mel Moss - Yanıt

  • When removing the casing, do not drop the small black plastic piece. This piece sits in a small gap above the lens, to the left of the flash, and underneath the camera case.

  • Remove the small black plastic piece and set it aside.

  • If necessary, use tweezers to remove the small black plastic piece.

  • Detach the front case and back case.

Suggest adding an image to show which piece the guide is referring to. It is difficult to understand without the camera.

Change the following directions to: "If necessary, use a tweezers to carefully remove the small black plastic piece."

Mel Moss - Yanıt

  • Do not remove the metal plate this step refers to. Removal at this step may damage the ribbon cable. Wait until the next step to remove the plate.

  • Remove the 3.5 mm screw that sits on the metal plate at the bottom of the camera.

  • Remove the two other 3.5 mm screws that sit on the side, to the left of the screw you just removed.

  • In the image, we have already removed some of the screws.

Yorum Ekle

  • A ribbon cable attaches to the metal plate and to the main circuit board, on the front of the camera.

  • Gently release the black latch.

  • Remove the ribbon cable and metal plate assembly.

Yorum Ekle

  • On the backside of the camera, remove the 3.5 mm screw that sits to the left of the viewfinder and above the LCD screen.

  • Remove the second 3.5 mm screw that sits directly above the LCD screen.

  • Gently detach the ribbon cable.

Yorum Ekle

  • Locate the ribbon cable on the main circuit board, which sits below the lens.

  • Gently release the black latch on the ribbon cable connector and detach the ribbon cable.

Yorum Ekle

  • Remove the LCD screen and set it aside.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Ross Bryan

Üyelik tarihi: 21-01-2011

350 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 5-19, Amido Winter 2011 Cal Poly, Team 5-19, Amido Winter 2011 üyesi

CPSU-AMIDO-W11S5G19

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 2

Son 30 Gün: 4

Her zaman: 2,651