Giriş

Use this guide to replace the front panel of the camera as well as the battery door.

Place camera LCD side up and press up on the battery door. Let it swing open until you can see the battery inside.
  • Place camera LCD side up and press up on the battery door.

  • Let it swing open until you can see the battery inside.

Yorum Ekle

Press down on the orange plastic.
  • Press down on the orange plastic.

  • This will gently eject the battery from its compartment.

Yorum Ekle

Holding the edges, slide out the battery. Holding the edges, slide out the battery.
  • Holding the edges, slide out the battery.

Yorum Ekle

Look at the camera from the side with the lanyard and 4 screws.
  • Look at the camera from the side with the lanyard and 4 screws.

    • Remove the two 3.4 mm screws on the metallic colored part.

Yorum Ekle

Remove the 3mm screw on the top left.
  • Remove the 3mm screw on the top left.

    • NOTE: When reassembling, it is helpful to put the top screw back in before placing the front cover back on the camera.

  • Now remove the 5.3mm screw on the bottom.

Yorum Ekle

Place the camera LCD side down.
  • Place the camera LCD side down.

  • Remove the two 5.3mm screws by the battery door.

Yorum Ekle

Remove the four 3.4mm screws on the bottom of the camera around the tripod mount.
  • Remove the four 3.4mm screws on the bottom of the camera around the tripod mount.

    • Make sure to keep these screws separate from the previous 5.3 mm screws.

Yorum Ekle

Stand the camera back up.
  • Stand the camera back up.

  • Remove the two 3.6mm screws on the side with the A/V Out port.

Yorum Ekle

Lift open the rubber flap covering the A/V Out port.
  • Lift open the rubber flap covering the A/V Out port.

    • Remove the 3.4mm screw in the center.

    • During reassembly, put the A/V out rubber door on before replacing the front panel of the camera

Yorum Ekle

Use a spudger and gently open up the front panel of the camera.
  • Use a spudger and gently open up the front panel of the camera.

    • A thin plastic ribbon will stay connected by a brown piece to front panel of the camera.

Yorum Ekle

There will be a brown plastic piece keeping the thin plastic ribbon in place.
  • There will be a brown plastic piece keeping the thin plastic ribbon in place.

  • Use the spudger to pull out the brown plastic piece attached to the orange plastic.

Yorum Ekle

Use a pair of tweezers and remove the metal piece inside the camera.
  • Use a pair of tweezers and remove the metal piece inside the camera.

Yorum Ekle

Remove the battery door
  • Remove the battery door

    • NOTE: Putting this back on requires aligning the spring on the back of the door with the hole on the camera

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Karim

Üyelik tarihi: 12-04-2012

24 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 7-34, Maness Spring 2012 Cal Poly, Team 7-34, Maness Spring 2012 üyesi

CPSU-MANESS-S12S7G34

5 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 2

Son 30 Gün: 7

Her zaman: 848