Ana içeriğe geç

Giriş

The buttons on the user interface panel can become broken or stuck. This guide will show how to replace the user interface panel on the device.

  1. Remove the 2.0 mm Phillips screws on both sides of the camera using the J00 bit from the 54 bit Driver Kit There will be 4 total screws that need to be removed, 2 on each side There will be 4 total screws that need to be removed, 2 on each side
    • Remove the 2.0 mm Phillips screws on both sides of the camera using the J00 bit from the 54 bit Driver Kit

    • There will be 4 total screws that need to be removed, 2 on each side

  2. Remove the 4.0 mm Phillips screw located on the bottom of the camera
    • Remove the 4.0 mm Phillips screw located on the bottom of the camera

  3. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  4. Remove the front face panel of the camera.
    • Remove the front face panel of the camera.

    • The face can be removed by hand with a firm pressure. If one point of the face is stuck to the body, ensure that there is not a screw remaining at that position to hold it in place.

  5. Remove the rear panel of the camera.
    • Remove the rear panel of the camera.

    • This can be done by hand without tools using firm pressure

  6. Remove the user interface panel by hand
    • Remove the user interface panel by hand

    • The panel may fall out on its own, this is normal.

    • Replace the user interface panel by setting it in position.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Braxton Beal

Üyelik tarihi: 30-01-2018

672 İtibar

3 adet Kılavuz yazıldı

Takım

Baylor, Team S1-G3, Johnson Spring 2018 Baylor, Team S1-G3, Johnson Spring 2018 üyesi

BU-JOHNSON-S18S1G3

3 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 74