Giriş

Follow these steps to remove and install a new LCD screen.

Parçalar

Hiçbir parçaya gerek yok.

  1. Turn off camera by pressing power button above the LCD screen.
    • Turn off camera by pressing power button above the LCD screen.

    • Remove the battery and memory card.

  2. Remove the screws on the bottom of the camera using a 00 Philip's head screw driver
    • Remove the screws on the bottom of the camera using a 00 Philip's head screw driver

  3. Remove the screws on the right side of the camera.
    • Remove the screws on the right side of the camera.

  4. Pro Tech Toolkit içeren veya $100,00tüm siparişlerde ücretsiz kargo!

    Mağazamıza Göz Atın

    Ever fixed something? That’s Genius.

    Share your repair story with #ImAGenius

    We Are All Geniuses

    Share your repair story with #ImAGenius

  5. Remove the screws on the left of the camera underneath the "A/V out Digital" cover flap.
    • Remove the screws on the left of the camera underneath the "A/V out Digital" cover flap.

  6. Remove the screws on the bottom of the camera near the battery and the memory card slots.
    • Remove the screws on the bottom of the camera near the battery and the memory card slots.

    • This screw is longer than the rest of the screws.

  7. Remove the front back and side casings from the camera.
    • Remove the front back and side casings from the camera.

  8. Remove the two screws that connect the LCD and backlight to the main body of the camera.
    • Remove the two screws that connect the LCD and backlight to the main body of the camera.

  9. Gently pry the LCD and the backlight from the main body of the camera. Gently pry the LCD from the backlight. The thin ribbon cable is for the backlight.
    • Gently pry the LCD and the backlight from the main body of the camera.

    • Gently pry the LCD from the backlight.

      • The thin ribbon cable is for the backlight.

      • The thick ribbon cable is for the LCD screen.

  10. Carefully lift the ZIF connector that covers the thick ribbon cable.
    • Carefully lift the ZIF connector that covers the thick ribbon cable.

    • This ZIF connector is fragile. Use caution when lifting it from its down position.

    • Insert the new LCD and reassemble the camera.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

Emilio Rossi

Üyelik tarihi: 07-04-2011

113 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 9-71, Walters Spring 2011 Cal Poly, Team 9-71, Walters Spring 2011 üyesi

CPSU-WALTERS-S11S9G71

4 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 2

Her zaman: 2,349