Giriş

The screen is a crucial part of the camera: it displays images for consumers to view their pictures instantly. Damage to the screen may require replacement.

Parçalar

Hiçbir parçaya gerek yok.

Slide grey latch to open the battery compartment.
  • Slide grey latch to open the battery compartment.

Yorum Ekle

Push orange retaining clip to the right to free battery.
  • Push orange retaining clip to the right to free battery.

Yorum Ekle

  • Remove battery from the camera.

Yorum Ekle

  • Remove the lanyard.

Yorum Ekle

  • Remove the two 2.3mm screws (underneath the name plate) and two 2.8mm screws (next to the threaded tripod mount) from the bottom face of the camera.

  • Be careful to keep track of the different screw sizes as you proceed with this guide.

Yorum Ekle

  • Remove the single 3.8mm screw from the back face of the camera.

Yorum Ekle

  • Remove the two 2.3mm screws from the right face of the camera.

Yorum Ekle

  • Remove the two 3.2mm screws (outside edge) and two 3.7mm screws (towards middle) from the left side of the camera body.

Yorum Ekle

  • Pull the back face panel away from the front end of the body. This may take some wiggling and force.

Yorum Ekle

  • Remove the CF card door from the left side of the camera body.

Yorum Ekle

  • Remove the rubber digital a/v out cap by sliding it out of the groove on the front plate.

Yorum Ekle

  • Remove the front face by sliding it off.

Yorum Ekle

  • Remove the rubber seal that goes over the right side of the viewfinder.

Yorum Ekle

  • Remove the two 3.9mm screws that retain the laminated cooper sheet.

Yorum Ekle

  • Remove the seven wire connections that connect to the motherboard.

Yorum Ekle

  • Remove the single 3.8mm screw that is on the motherboard.

Yorum Ekle

  • Carefully remove the motherboard from the main frame of the camera body.

Yorum Ekle

  • After completing the removal of the motherboard, remove the tripod mounting screws (3.4mm) on the left side

Yorum Ekle

  • Carefully pry the left side of the housing plate from the bottom of the tripod mounting plate, releasing it from the two alignment pegs next to the screws

Yorum Ekle

  • Lift the left side of the tripod mounting plate towards you, lift free the mounting plate from the rest of the assembly

  • Be careful because there are still wire connections attached to the mounting plate which you don't want to remove

Yorum Ekle

  • Remove the 2.1mm screws from the bottom and top of the screen connecting it to the housing plate

Yorum Ekle

  • Unsolder the four points at the top of the screen with a soldering iron

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Anh

Üyelik tarihi: 13-04-2011

121 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team 20-70, Walters Spring 2011 Cal Poly, Team 20-70, Walters Spring 2011 üyesi

CPSU-WALTERS-S11S20G70

5 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 1,370