Giriş

Use this guide to clean the function buttons.

Aletler

Parçalar

Hiçbir parçaya gerek yok.

  1. Remove wrist strap and battery.
    • Remove wrist strap and battery.

    Yorum Ekle

  2. Remove 2 screws from each side of the camera (4 total, 0.102 in).
    • Remove 2 screws from each side of the camera (4 total, 0.102 in).

    • Remove 2 screws from the bottom on the camera (0.138 in).

    • Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.

    Yorum Ekle

    • Gently pull off the front cover.

    • The plate on the side should come off.

    • Gently pull off the back cover.

    Yorum Ekle

    • The cases should now be removed.

    This can be a bit tricky when reassembling. All of the little tabs around the edge need to snap into their proper places, and there are three cover pieces to manage. Plus, you need to make sure that the camera/video/playback switch is properly engaged with its slider on the circuit board, otherwise you'll need to raise the back panel and reposition everything again.

    Craig Bonsignore - Yanıt

    oh yes , i agree lol

    elbala80 -

    • Clean around the function buttons with a cotton swab dipped in isopropyl alcohol.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Tyler Grossheim

Üyelik tarihi: 25-01-2011

1.359 İtibar

6 adet Kılavuz yazıldı

Takım

Cal Poly, Team 3-32, Regan Winter 2011 Cal Poly, Team 3-32, Regan Winter 2011 üyesi

CPSU-REGAN-W11S3G32

3 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 4

Her zaman: 1,818