Press the eject button to view the laser inside.
  • Press the eject button to view the laser inside.

  • Using the blue plastic tool and the tweezers, remove the ribbon cable.

Yorum Ekle

Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver.
  • Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver.

  • Do not lift the top of the DVD player too quickly because there are wires attached on the inside.

  • Pry the top of the device open from the right side where the buttons are located.

Yorum Ekle

  • When pulling the ribbon cables out, make sure not to pull by the wires, as this can cause damage to them.

  • Pinch the plastic adapter with two fingers to remove the wires circled in red from the circuit board.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Kyle VanAllen

Üyelik tarihi: 20-01-2012

70 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 10-36, Amido Winter 2012 Cal Poly, Team 10-36, Amido Winter 2012 üyesi

CPSU-AMIDO-W12S10G36

4 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 209