Ana içeriğe geç

Commercial 8 Quart Bowl-Lift Stand Mixer - Switch Guard Replacement

Neye ihtiyacın var

    • Before starting ANY repair/disassembly of the mixer, make sure it is fully unplugged from the electrical outlet.

    • If this mixer is being used in a commercial environment, a LOTO tag can be affixed via the hole on one of the prongs on the mains plug to prevent accidental activation.

  1. Commercial 8 Quart Bowl-Lift Stand Mixer - Switch Guard Replacement, Remove the trim band: adım 2, 1 resimden 1.
    • Using a #2 Philips Screwdriver, remove the screw which holds on the trim band.

    • Remove the trim band.

  2. Commercial 8 Quart Bowl-Lift Stand Mixer - Switch Guard Replacement, Remove the motor housing: adım 3, 3 resimden 1. Commercial 8 Quart Bowl-Lift Stand Mixer - Switch Guard Replacement, Remove the motor housing: adım 3, 3 resimden 2. Commercial 8 Quart Bowl-Lift Stand Mixer - Switch Guard Replacement, Remove the motor housing: adım 3, 3 resimden 3.
    • Remove the four screws (circled in yellow, two on each side) using a #2 Philips Screwdriver

    • Remove the motor housing by lifting it straight up.

  3. Commercial 8 Quart Bowl-Lift Stand Mixer - Switch Guard Replacement, Remove the old switch guard: adım 4, 3 resimden 1. Commercial 8 Quart Bowl-Lift Stand Mixer - Switch Guard Replacement, Remove the old switch guard: adım 4, 3 resimden 2. Commercial 8 Quart Bowl-Lift Stand Mixer - Switch Guard Replacement, Remove the old switch guard: adım 4, 3 resimden 3.
    • Using a #2 Phillips screwdriver, remove the single screw attaching the switch guard to the mixer body.

    • The second image shows the rough location of the screw, while the third image shows an unobstructed view of said screw.

Sonuç

To reassemble your device, follow these instructions in reverse order.

PedroDaGr8

Üyelik tarihi: 08/12/12

2.971 İtibar

15 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 5

Son 30 gün: 14

Her zaman: 245