Ana içeriğe geç

Giriş

A guide on how to remove the Heat Spreader.

  1. Turn the laptop bottom side up with the rear panel facing forward.
    • Turn the laptop bottom side up with the rear panel facing forward.

  2. Remove the two T8 Torx screws that secure the LED cover to the base enclosure.
    • Remove the two T8 Torx screws that secure the LED cover to the base enclosure.

  3. Turn the laptop top side up with the front facing forward. Open the screen.
    • Turn the laptop top side up with the front facing forward. Open the screen.

  4. Locate the F1 and F2 keys near the top left corner of the keyboard.
    • Locate the F1 and F2 keys near the top left corner of the keyboard.

  5. While holding the F1 and F2 keys, insert a spudger between the keys into the notch in the LED cover. Lift up.
    • While holding the F1 and F2 keys, insert a spudger between the keys into the notch in the LED cover. Lift up.

  6. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  7. Locate the Pause and Scroll keys near the top right corner of the keyboard.
    • Locate the Pause and Scroll keys near the top right corner of the keyboard.

  8. While holding the Pause and Scroll keys, insert a spudger between the keys into the notch in the LED cover. Lift up.
    • While holding the Pause and Scroll keys, insert a spudger between the keys into the notch in the LED cover. Lift up.

  9. Insert a spudger between the F7 and F8 keys. Lift up to remove the LED cover. Insert a spudger between the F7 and F8 keys. Lift up to remove the LED cover.
    • Insert a spudger between the F7 and F8 keys. Lift up to remove the LED cover.

  10. Lift the back edge of the keyboard and pull towards the screen.
    • Lift the back edge of the keyboard and pull towards the screen.

  11. Pull the cable and lift up to release.
    • Pull the cable and lift up to release.

  12. Remove the keyboard.
    • Remove the keyboard.

  13. Locate the fan near the top left corner. It has three colored wires: yellow, red, and black.
    • Locate the fan near the top left corner. It has three colored wires: yellow, red, and black.

    • Disconnect the cable connecting the fan to the system board.

  14. Locate and remove the four screws in the copper plate.
    • Locate and remove the four screws in the copper plate.

  15. Remove the heat spreader by pulling the whole assembly up out of the computer.
    • Remove the heat spreader by pulling the whole assembly up out of the computer.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

kim

Üyelik tarihi: 14-04-2010

47 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 29-74, Johann Spring 2010 Cal Poly, Team 29-74, Johann Spring 2010 üyesi

CPSU-JOHANN-S10S29G74

3 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 3,746