Giriş

Often times it is only necessary to replace the carbon brushes, not the motor. Carbon brushes experience a lot of friction, and replacement is generally expected over time. Ensure your saw is unplugged before beginning the repair

  1. Using a flathead screwdriver, remove the brush caps on the outer casing of the saw near the motor. Using a flathead screwdriver, remove the brush caps on the outer casing of the saw near the motor.
    • Using a flathead screwdriver, remove the brush caps on the outer casing of the saw near the motor.

  2. Pro Tech Toolkit içeren veya $100,00tüm siparişlerde ücretsiz kargo!

    Mağazamıza Göz Atın
  3. Using a Phillips #00 screwdriver or a small diameter nail, carefully pull out the washer.
    • Using a Phillips #00 screwdriver or a small diameter nail, carefully pull out the washer.

      • The washer is seurely held in place and may require force to remove

  4. After the washers are removed, gently grab the old brushes and remove them from the motor.
    • After the washers are removed, gently grab the old brushes and remove them from the motor.

      • When reassembling make sure the curvature of the brushes match curvature of the motor.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Riley Hilliker

Üyelik tarihi: 14-10-2014

561 İtibar

5 adet Kılavuz yazıldı

Takım

Cal Poly, Team 4-47, Amido Fall 2014 Cal Poly, Team 4-47, Amido Fall 2014 üyesi

CPSU-AMIDO-F14S4G47

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 2

Son 30 Gün: 9

Her zaman: 636