Ana içeriğe geç

Parçalar

Hiçbir parça belirtilmedi.

  1. Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.
    • Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.

  2. Remove the back casing to expose the circuit board.
    • Remove the back casing to expose the circuit board.

  3. Detach the gray antenna wires by gently pulling on the side closest to the circuit board.
    • Detach the gray antenna wires by gently pulling on the side closest to the circuit board.

  4. Detach the speaker wire by gently pulling on the side closest to the body of the camera.
    • Detach the speaker wire by gently pulling on the side closest to the body of the camera.

  5. Remove the two 7.25 mm screws  using the Ph00  head.
    • Remove the two 7.25 mm screws using the Ph00 head.

  6. Remove the back grey speaker plate
    • Remove the back grey speaker plate

  7. Remove the speaker by gently pulling on the wire near the speaker.
    • Remove the speaker by gently pulling on the wire near the speaker.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Collyn Dodge

Üyelik tarihi: 21-03-2018

305 İtibar

2 adet Kılavuz yazıldı

Takım

IUPUI, Team S4-G2, Baechle Spring 2018 IUPUI, Team S4-G2, Baechle Spring 2018 üyesi

IUPUI-BAECHLE-S18S4G2

3 Üyeler

3 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 2

Her zaman: 72