Ana içeriğe geç

Giriş

If the security camera image is not clear or does not show any picture, at first, take a look at the lens of the camera. If the lens of the camera was scratched or broken follow this replacement guide to replace the broken lens with a new one.

  1. D-Link DCS-5222L Lens Replacement, Lens: adım 1, 3 resimden 1. D-Link DCS-5222L Lens Replacement, Lens: adım 1, 3 resimden 2. D-Link DCS-5222L Lens Replacement, Lens: adım 1, 3 resimden 3.
    • Remove the four rubber feet with tweezers to access the screws.

    • Remove all four 7mm screws by using a #1 Phillips screwdriver.

    • Then, with your hands, pull off the lower part of the camera body.

  2. D-Link DCS-5222L Lens Replacement: adım 2, 3 resimden 1. D-Link DCS-5222L Lens Replacement: adım 2, 3 resimden 2. D-Link DCS-5222L Lens Replacement: adım 2, 3 resimden 3.
    • On the base motherboard, there are five connecting cables. Disconnect all of them from the motherboard gently using safety tweezers.

    • Do not cut or damage the cables.

    • Disconnecting the antenna cable from motherboard is not necessary.

  3. D-Link DCS-5222L Lens Replacement: adım 3, 3 resimden 1. D-Link DCS-5222L Lens Replacement: adım 3, 3 resimden 2. D-Link DCS-5222L Lens Replacement: adım 3, 3 resimden 3.
    • Remove the two 7mm screws holding the motor using a #1 Phillips screwdriver.

    • Pull off the motor and lift away the midbody of the camera using your hands.

  4. D-Link DCS-5222L Lens Replacement: adım 4, 2 resimden 1. D-Link DCS-5222L Lens Replacement: adım 4, 2 resimden 2.
    • Separate the black camera shroud from the upper body by prying loose the tabs with a plastic opening tool or spudger.

    • Use your hands to wiggle the shroud free.

  5. D-Link DCS-5222L Lens Replacement: adım 5, 3 resimden 1. D-Link DCS-5222L Lens Replacement: adım 5, 3 resimden 2. D-Link DCS-5222L Lens Replacement: adım 5, 3 resimden 3.
    • Use a #1 Phillips screwdriver to unscrew the four 5mm screws on both sides of the black camera housing to separate it from white body.

    • Unscrew the two 7mm #1 Phillips screws on both sides of the camera housing to open it.

  6. D-Link DCS-5222L Lens Replacement: adım 6, 3 resimden 1. D-Link DCS-5222L Lens Replacement: adım 6, 3 resimden 2. D-Link DCS-5222L Lens Replacement: adım 6, 3 resimden 3.
    • Gently disconnect the three cables from the small motherboard using safety tweezers.

    • Use a #0 Phillips screwdriver to remove the two black 2mm screws and a #1 Phillips screwdriver to remove the 2 silver 6mm screws.

    • Separate the board from the black housing.

  7. D-Link DCS-5222L Lens Replacement: adım 7, 3 resimden 1. D-Link DCS-5222L Lens Replacement: adım 7, 3 resimden 2. D-Link DCS-5222L Lens Replacement: adım 7, 3 resimden 3.
    • Using your fingers, remove the focus adjustment ring.

    • Twist the lens to unscrew it from the camera module.

    • Replace the broken lens with new one and reassemble all parts of the camera respectively.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Atefeh Rahmani

Üyelik tarihi: 27-10-2018

148 İtibar

1 Kılavuz yazıldı

Team

UMass Dartmouth, Team S2-G5, Peak Fall 2018 UMass Dartmouth, Team S2-G5, Peak Fall 2018 üyesi

UMASSD-PEAK-F18S2G5

3 Üyeler

10 adet Kılavuz yazıldı

0 Comments

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 3

Son 7 gün: 7

Son 30 gün: 25

Her zaman: 705