D-Link DCS-825L Antenna Replacement

Giriş

There are times that the antenna of the Wi-Fi Baby Camera does not work. This is a step by step guide on how to remove a faulty antenna from the Wi-Fi Baby Camera and replacing it with a working antenna.

Neye ihtiyacın var

Adım 1 Accent Ring

D-Link DCS-825L Antenna Replacement, Accent Ring: adım 1, 1 resimden 1.

Grasp the side of the accent ring. There is a notch that your thumb will be able to grab ahold of.

Düzenle

Adım 2

Twist the accent ring until it pops off. You may need to use both hands if the accent ring is stuck.

Düzenle

Adım 3

Replace your accent ring with whichever color you choose.

Düzenle

Adım 4 Back Casing

D-Link DCS-825L Antenna Replacement, Back Casing: adım 4, 2 resimden 1.

D-Link DCS-825L Antenna Replacement, Back Casing: adım 4, 2 resimden 2.

Remove one Phillips #2 screw from each side of the camera lens.

Düzenle

Adım 5

D-Link DCS-825L Antenna Replacement: adım 5, 3 resimden 3.

Pull the Wi-Fi Baby Camera open.
It should be easily done after the screws are removed.

Düzenle

Adım 6

Take your tweezers and gently pull the white tip out from its plug that is connected to a red and black twisted wire.

Düzenle

Adım 7

D-Link DCS-825L Antenna Replacement: adım 7, 3 resimden 3.

Take your tweezers and gently pull the white tip that is on the end of the white wire (the antenna) out from its plug in.

Düzenle

Adım 8 Antenna

D-Link DCS-825L Antenna Replacement, Antenna: adım 8, 1 resimden 1.

Once you have the back casing removed from the other half of the device, it should look like this with the antenna poking out.

Düzenle

Adım 9

D-Link DCS-825L Antenna Replacement: adım 9, 3 resimden 3.

There will be a light yellow rubber stopper that is holding the antenna in place.
With your tweezers, gently tug on the stopper to make it come out, or at least come loose.
If the stopper does not completely come out, use the round top of the antenna to push down on it.
You can do this simply by pulling the antenna as close to the back casing as possible, and then pushing down on it until the rubber stopper comes out completely.
After it has come out, it can either be taken off from the antenna and set aside, or it can be kept on.

Düzenle

Adım 10

Once the rubber stopper has been pushed out, you will now be able to easily pull the antenna out from the back casing.
After it has been removed, you are now able to replace the antenna of your Wi-Fi Baby Camera.

Düzenle