Ana içeriğe geç

Giriş

Does the LED light cover have a crack on the outer cap? Is it yellowed or discolored? This guide will show you the way to replace the LED light cover for your Wi-Fi Baby Camera.

  1. Grasp the side of the accent ring. There is a notch that your thumb will be able to grab ahold of.
    • Grasp the side of the accent ring. There is a notch that your thumb will be able to grab ahold of.

  2. Twist the accent ring until it pops off. You may need to use both hands if the accent ring is stuck.
    • Twist the accent ring until it pops off. You may need to use both hands if the accent ring is stuck.

  3. Replace your accent ring with whichever color you choose.
    • Replace your accent ring with whichever color you choose.

  4. Take your Phillips Head screwdriver, with a long neck, and unscrew the two screws - one in each hole on either side of the outer exposed camera lens. Take your Phillips Head screwdriver, with a long neck, and unscrew the two screws - one in each hole on either side of the outer exposed camera lens.
    • Take your Phillips Head screwdriver, with a long neck, and unscrew the two screws - one in each hole on either side of the outer exposed camera lens.

  5. Skip the upgrade.

    Take $10 off $50 with
    SKIPANDSAVE10

    Save Now

    Skip the upgrade.

    Take $10 off $50 with
    SKIPANDSAVE10

    Save Now
  6. Pull the WiFi Baby Camera open. It should be easily done after the screws are removed. It should be easily done after the screws are removed.
    • Pull the WiFi Baby Camera open.

    • It should be easily done after the screws are removed.

  7. Take your tweezers and gently pull the white tip out from its plug that is connected to a red and black twisted wire. Take your tweezers and gently pull the white tip out from its plug that is connected to a red and black twisted wire.
    • Take your tweezers and gently pull the white tip out from its plug that is connected to a red and black twisted wire.

  8. Take your tweezers and gently pull the white tip that is on the end of the white wire (the antenna) out from its plug in. Take your tweezers and gently pull the white tip that is on the end of the white wire (the antenna) out from its plug in. Take your tweezers and gently pull the white tip that is on the end of the white wire (the antenna) out from its plug in.
    • Take your tweezers and gently pull the white tip that is on the end of the white wire (the antenna) out from its plug in.

  9. Grab the white cylinder with your thumb and index finger.
    • Grab the white cylinder with your thumb and index finger.

  10. Gently lift the cylinder up from its placement in your WiFi Baby Camera.
    • Gently lift the cylinder up from its placement in your WiFi Baby Camera.

  11. Remove the white cylinder completely to replace it.
    • Remove the white cylinder completely to replace it.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Annalise Leclair

Üyelik tarihi: 09-10-2018

97 İtibar

1 Kılavuz yazıldı

Takım

USF Tampa, Team S1-G5, Leahy Fall 2018 USF Tampa, Team S1-G5, Leahy Fall 2018 üyesi

USFT-LEAHY-F18S1G5

4 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 2

Her zaman: 68