Eşyalarını Tamir Et Topluluk Mağaza

DeWalt DW920 Motor Replacement

Neye ihtiyacın var

  1. DeWalt DW920 Motor Replacement, Disassembly: adım 1, 1 resimden 1.

    • Using an H-5.0 bit driver remove the four T-10 Torx screws.

    Düzenle

  2. DeWalt DW920 Motor Replacement: adım 2, 1 resimden 1.

    • Use 2 H-5.0 bit drivers to take out the main bolt and head.

    • There will be blue locktite on the tread.

    Düzenle

  4. DeWalt DW920 Motor Replacement: adım 3, 1 resimden 1.

    • Carefully remove the two halves of the handle.

    Düzenle

  5. DeWalt DW920 Motor Replacement, Motor: adım 4, 1 resimden 1.

    • Gently lift the motor and trigger mechanism out from the frame of the drill.

    Düzenle

  6. DeWalt DW920 Motor Replacement: adım 5, 1 resimden 1.

    • Locate where the motor assembly is attached to the trigger mechanism and carefully detach the wires at their solder points.

    • Mark where the two cables was connected using a masking tape or similar.

    Düzenle

  7. DeWalt DW920 Motor Replacement: adım 6, 1 resimden 1.

    • Solder the new motor assembly wires to the trigger mechanism in the same fashion that the old motor was.

    • Remember to check the markers from the step before and solder the cables on the right place.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

4 tane daha katılımcı ile

Stephen Rada

Üyelik tarihi: 03/11/16

433 İtibar

4 adet Kılavuz yazıldı

Rozetler: 9

+6 tane daha rozet

Ekip

UMass Dartmouth, Team 8-2, Botvin Spring 2016 UMass Dartmouth, Team 8-2, Botvin Spring 2016 üyesi

UMASSD-BOTVIN-S16S8G2

2 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 3

Her zaman: 795