Tehlike
Tehlikeli Olma Potansiyeli Var
Bu talimat doğru şekilde uygulanmazsa yaralanma meydana gelebilir. Dikkatli olun ve tüm uyarıları takip edin.
Tehlike

Giriş

Following this guide involves completely disassembling the monitor. This process isn't terribly difficult, just time consuming.

Carefully place the monitor face down on a flat surface, being careful to protect the display.
  • Carefully place the monitor face down on a flat surface, being careful to protect the display.

  • Remove the four 10 mm Phillips #2 screws from the back panel.

Yorum Ekle

Flip the monitor back over, so that the display is facing you.
  • Flip the monitor back over, so that the display is facing you.

  • Use a spudger to remove the front bezel by unsnapping it in a counter clockwise fashion, starting at the bottom right, and ending at the button panel.

Yorum Ekle

  • Slowly unsnap the bezel around the buttons.

  • Be careful to not fully remove the bezel here, because a ribbon cable attaches the buttons to the monitor.

Yorum Ekle

  • Carefully flip the monitor back over, making sure to keep the front bezel in place.

  • Lift the back cover off of the rest of the monitor.

Yorum Ekle

  • Locate the USB port cover on the right hand side of the monitor.

  • Remove the one 5 mm Phillips #2 screw.

  • Remove the USB port cover by sliding it out and away from the monitor.

Yorum Ekle

  • Disconnect the USB ports by gentling grasping and pulling on the connector.

Yorum Ekle

  • Remove the five 5 mm Phillips #2 screws from the back panel.

Yorum Ekle

  • Remove the four 4 mm Phillips #2 screws that secure the monitor mount release mechanism to the panel.

  • Set this mechanism off to the side, taking care to keep it all in one piece.

Yorum Ekle

  • Use a 5 mm nut driver to remove the four 12 mm standoff screws securing the video connectors to the panel.

Yorum Ekle

  • Use the tweezers to lift up the seven security tabs that secure the back panel to the rest of the monitor.

  • If the security tabs are held down too tightly, use the spudger to pry them up, and then finish them off with the tweezers.

Yorum Ekle

  • Lift up on the back panel to remove it from the rest of the monitor.

  • Be careful when doing so, as the edges of the back panel can be very sharp.

Yorum Ekle

  • Use the tweezers to remove the four connectors from the power supply board.

  • The power supply has several large capacitors (they look like little cylinders), that can shock you if they discharge. Be careful not to touch them as you continue to work.

Yorum Ekle

  • Remove the five 7 mm Phillips #2 screws from the power supply board.

Yorum Ekle

  • Open up the clip securing the wires running between the power supply and video boards.

  • Gently remove the connector running from the video board to the power supply board.

Yorum Ekle

  • The power supply board can now be removed.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Geoff Wacker

Üyelik tarihi: 30-09-2013

70.663 İtibar

84 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 8

Son 30 Gün: 41

Her zaman: 2,514