Ana içeriğe geç

Parçalar

Hiçbir parça belirtilmedi.

  1. Remove the eight 6mm back panel screws with your PH1 Phillips head screw driver bit. Use your screw driver to remove the plastic cover  in the center of the laptop.
    • Remove the eight 6mm back panel screws with your PH1 Phillips head screw driver bit.

    • Use your screw driver to remove the plastic cover in the center of the laptop.

    • Using a PH1 Phillips head screw driver bit remove the last 6mm screw.

  2. Use your metal pry tool to pry around the laptop until the two pieces separate. There will be a ribbon cable holding the two pieces together, be careful not to rip it out of it's socket.
    • Use your metal pry tool to pry around the laptop until the two pieces separate.

    • There will be a ribbon cable holding the two pieces together, be careful not to rip it out of it's socket.

    • Use your metal pry tool to release the connector.

  3. Remove the speaker plug from it's socket. Lift the speaker assembly from the case.
    • Remove the speaker plug from it's socket.

    • Lift the speaker assembly from the case.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Michael Kendziora

Üyelik tarihi: 14-02-2018

775 İtibar

5 adet Kılavuz yazıldı

Takım

USF Tampa, Team S6-G4, Eyestone Spring 2018 USF Tampa, Team S6-G4, Eyestone Spring 2018 üyesi

USFT-EYESTONE-S18S6G4

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 4

Son 7 Gün: 4

Son 30 Gün: 4

Her zaman: 68