Ana içeriğe geç

Giriş

In this guide, we will show you how to remove and replace the Display Assembly.

Parçalar

Hiçbir parça belirtilmedi.

  1. WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.
    • WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.

    • Peel off the pieces of tape that secure the display cable and touch-screen board-cable to the system board.

  2. Open the latches to disconnect the display cable and the touch-screen board-cable from the system board.
    • Open the latches to disconnect the display cable and the touch-screen board-cable from the system board.

  3. Turn the computer over and open the display as far as possible.
    • Turn the computer over and open the display as far as possible.

  4. CAUTION: Place the computer on a soft and clean surface to avoid scratching the display.
    • CAUTION: Place the computer on a soft and clean surface to avoid scratching the display.

    • Place the computer face down on a flat surface.

  5. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  6. Remove the screws that secure the display assembly to the palm-rest assembly.
    • Remove the screws that secure the display assembly to the palm-rest assembly.

  7. Lift the display assembly off the palm-rest assembly.
    • Lift the display assembly off the palm-rest assembly.

  8. Place the NEW display assembly face down on the palm-rest assembly.
    • Place the NEW display assembly face down on the palm-rest assembly.

  9. Align the screw holes on the display hinges with the screw holes on the palm-rest assembly.
    • Align the screw holes on the display hinges with the screw holes on the palm-rest assembly.

    • Close the display and turn the computer over.

  10. Slide the display cable and the touch-screen board-cable into their respective connectors on the system board and close the latches to secure the cables. Slide the display cable and the touch-screen board-cable into their respective connectors on the system board and close the latches to secure the cables.
    • Slide the display cable and the touch-screen board-cable into their respective connectors on the system board and close the latches to secure the cables.

  11. Adhere the pieces of tape that secure the display cable and the touch-screen board-cable to their respective connectors on the system board.
    • Adhere the pieces of tape that secure the display cable and the touch-screen board-cable to their respective connectors on the system board.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Terrence15

Üyelik tarihi: 18-12-2017

70.785 İtibar

442 adet Kılavuz yazıldı

Takım

Informative Technologies Inc. Informative Technologies Inc. üyesi

Community

15 Üyeler

925 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 8

Son 30 Gün: 57

Her zaman: 596