Giriş

This may be needed if your touchpad is not working as it usually does.

  1. Turn off laptop before beginning.
    • Turn off laptop before beginning.

    • Place the laptop upside down on a flat, stable surface.

  2. Remove the 3mm screw in the location shown, using a Phillips #1 screwdriver.
    • Remove the 3mm screw in the location shown, using a Phillips #1 screwdriver.

    • Remove the panel from the sides and pull it out at an angle towards you.

    • Remove the five 3mm screws on the battery with a Torx (T8) screwdriver in the locations shown.

    • Disconnect the power cord from the battery by using a pair of tweezers, your fingers, or the opening tools from the iFixit pro tech tool kit.

    • Pinch the clips on the left and right side while pulling on the cord at the same time.

    • Pull the battery towards you.

    • Make sure to pull at an upward angle.

    • Remove the clip holding the power cord on the Touch Pad by using tweezers, your fingers, or iFixit removing tools to gently pull up on the clip.

    • This should release the power cord as shown.

    • Remove the four 3mm screws using a Phillips #1 screwdriver in the locations shown.

    • Remove Touch Pad by pulling towards you gently at a slight upward angle.

    • The Touch Pad is now removed and ready to be replaced.

Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 32

Her zaman: 65