Giriş

You would need to be removing the keyboard to access the heatsink and fan. If you need to, add a new layer of Arctic Silver Thermal Paste.

Parçalar

Hiçbir parçaya gerek yok.

  1. Remove battery
    • Remove battery

    • Open screen so that it lies flat.

    Yorum Ekle

  2. Starting from the right side of the hinge cover,  use the flat end of the spudger to pry up the hinge cover and gently remove it.
    • Starting from the right side of the hinge cover, use the flat end of the spudger to pry up the hinge cover and gently remove it.

    Yorum Ekle

    • Remove the four M2 x 3-mm screws holding in the keyboard.

    Yorum Ekle

    • Lift keyboard and detach the interface connector.

    • Take extra care when removing and handling the keyboard. The key caps on the keyboard are fragile, easily dislocate and would be time-consuming to replace.

    Yorum Ekle

    • Detach screen connector

    Yorum Ekle

    • Remove two screws (5.8mm) located behind the screen.

    Yorum Ekle

    • Remove one screw (8.6 mm) on metal plating.

    • Remove the metal plating

    Yorum Ekle

    • Loosen four screws.

    • These screws are attached to the heat sink and cannot be completely removed.

    Yorum Ekle

    • Disconnect the wire connecting the heatsink to the motherboard.

    Yorum Ekle

    • Slide the heatsink away from the screen and lift.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

May Chauvin

Üyelik tarihi: 14-04-2011

186 İtibar

6 adet Kılavuz yazıldı

Takım

Cal Poly, Team 12-34, Maness Spring 2011 Cal Poly, Team 12-34, Maness Spring 2011 üyesi

CPSU-MANESS-S11S12G34

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 2

Son 30 Gün: 18

Her zaman: 3,007