Giriş

Replacing the screen on a Dell Inspiron 910.

Turn the laptop over to where the battery is facing upwards and towards you.
  • Turn the laptop over to where the battery is facing upwards and towards you.

  • Locate the release tabs located on either side of the battery.

  • Push the release tabs toward the center of the device.

  • Remove the battery.

Yorum Ekle

Take the replacement battery, insert it into the original position  in the laptop.
  • Take the replacement battery, insert it into the original position in the laptop.

  • Slide the release tabs back into place.

Yorum Ekle

Use a plastic opening tool to pry the silver portion front of the top away from the colored portion.
  • Use a plastic opening tool to pry the silver portion front of the top away from the colored portion.

Yorum Ekle

There should be two screws holding the metal casing that holds the screen.  Using your Philips 0 Screwdriver, unscrew them and pull the casing outwards.
  • There should be two screws holding the metal casing that holds the screen. Using your Philips 0 Screwdriver, unscrew them and pull the casing outwards.

  • NOTE: Keep track of where you put the screws after you remove them. Keep screws of the same size together and away from screws of different sizes.

Yorum Ekle

Now that you've pulled out the screen casing, look for four screws, there will be two on the right and left side of the casing.
  • Now that you've pulled out the screen casing, look for four screws, there will be two on the right and left side of the casing.

  • Using your off hand's thumb, hold the screen in place. Using the Philips 0 Screwdriver, unscrew them.

  • Carefully remove your hand, and gently let the screen down.

Yorum Ekle

Disconnect the cord connecting the screen to the rest of the laptop; the cord will be affixed to the screen using tape, so it can be safely removed.  The actual cord connection is at the circuit board.
  • Disconnect the cord connecting the screen to the rest of the laptop; the cord will be affixed to the screen using tape, so it can be safely removed. The actual cord connection is at the circuit board.

Yorum Ekle

Pull down the laptop's back; the screen should be left upright, held in place by two metal strips going along its sides.
  • Pull down the laptop's back; the screen should be left upright, held in place by two metal strips going along its sides.

  • On either side of these strips there will be two screws. Unscrew them on both sides. While unscrewing the screws on the second side, make sure to hold the screen so that it doesn't fall when the screws are removed.

Yorum Ekle

Pull the screen out.  Congratulations!  You have removed the screen.
  • Pull the screen out. Congratulations! You have removed the screen.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

Kyle Beekman

Üyelik tarihi: 05-04-2012

141 İtibar

6 adet Kılavuz yazıldı

Takım

Cal Poly, Team 14-10, Forte Spring 2012 Cal Poly, Team 14-10, Forte Spring 2012 üyesi

CPSU-FORTE-S12S14G10

5 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 5

Her zaman: 2,064