Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

  1. Place the all in one computer face down on a soft, clean surface to avoid scratching the front. Press the tab on the stand cover and lift up. Press the tab on the stand cover and lift up.
    • Place the all in one computer face down on a soft, clean surface to avoid scratching the front.

    • Press the tab on the stand cover and lift up.

  2. Remove the four phillips screws that attach the stand to the computer. Tilt the stand up and out. Tilt the stand up and out.
    • Remove the four phillips screws that attach the stand to the computer.

    • Tilt the stand up and out.

  3. Starting from the optical drive, pry the back cover up with a plastic spudger. The cover is held in place by fragile plastic clips.  Careful to not break them. The cover is held in place by fragile plastic clips.  Careful to not break them.
    • Starting from the optical drive, pry the back cover up with a plastic spudger.

    • The cover is held in place by fragile plastic clips. Careful to not break them.

  4. Remove the three screws that hold the hard drive cage to the chassis. Remove the three screws that hold the hard drive cage to the chassis.
    • Remove the three screws that hold the hard drive cage to the chassis.

  5. Slide the hard drive cage out slightly to access and remove the power and SATA cable. There isn't much slack in these cables, so don't slide the hard drive cage to far.
    • Slide the hard drive cage out slightly to access and remove the power and SATA cable.

    • There isn't much slack in these cables, so don't slide the hard drive cage to far.

    • The power and SATA cables are connected together. On most other computers, these connectors are separate.

    • Lift the hard drive cage out.

  6. Remove the four screws (two on each side) that attach the hard drive cage to the hard drive. Lift the hard drive cage off the hard drive. Lift the hard drive cage off the hard drive.
    • Remove the four screws (two on each side) that attach the hard drive cage to the hard drive.

    • Lift the hard drive cage off the hard drive.

Sonuç

To reassemble your device, follow these instructions in reverse order.

32 farklı kişi bu kılavuzu tamamladı.

Tyler

Üyelik tarihi: 19-06-2012

4.662 İtibar

16 adet Kılavuz yazıldı

Takım

TechForce TechForce üyesi

Business

2 Üyeler

18 adet Kılavuz yazıldı

3 Yorum

Thanks for this info this is very useful

Thank you once again

Ketan Valsangkar - Yanıt

Good Job, short and sweet and easy to follow

schmidtrg - Yanıt

Really useful information thank you.

Jessie Colon - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 9

Son 7 gün: 56

Son 30 gün: 234

Her zaman: 29,292