Eşyalarını Tamir Et Topluluk Mağaza

Dell Latitude X300 Palm Rest/Track Pad Replacement

Giriş

This guide is for the removal and installation of new track pad and palm rest of the Dell Latitude X300

Neye ihtiyacın var

  1. Dell Latitude X300 Palm Rest/Track Pad Replacement, Battery: adım 1, 1 resimden 1.

    • Before removing the battery from the laptop, make sure the power is off.

    • Push both battery locking clips outward at the same time.

    Düzenle

  2. Dell Latitude X300 Palm Rest/Track Pad Replacement: adım 2, 1 resimden 1.

    • Slide the battery out of the laptop.

    Düzenle

  3. Dell Latitude X300 Palm Rest/Track Pad Replacement, Keyboard: adım 3, 1 resimden 1.

    • Remove the four 4 mm Phillips #0 screws from the bottom of the laptop.

    Düzenle

  4. Dell Latitude X300 Palm Rest/Track Pad Replacement: adım 4, 2 resimden 1. Dell Latitude X300 Palm Rest/Track Pad Replacement: adım 4, 2 resimden 2.

    • Carefully turn the laptop over and open the screen all the way.

    • Locate the slot to remove the keyboard in the lower left hand corner.

    • Using a spudger as a lever, insert it into the slot and gently pry up.

    Düzenle

  5. Dell Latitude X300 Palm Rest/Track Pad Replacement: adım 5, 1 resimden 1.

    • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

    • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

    Düzenle

  6. Dell Latitude X300 Palm Rest/Track Pad Replacement: adım 6, 1 resimden 1.

    • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

    Düzenle

  7. Dell Latitude X300 Palm Rest/Track Pad Replacement: adım 7, 1 resimden 1.

    • Remove the flexible ribbon from the ZIF connector.

    • Do not pull on the ribbon to remove it from the ZIF connector.

    Düzenle

  8. Dell Latitude X300 Palm Rest/Track Pad Replacement, Palm Rest/Track Pad: adım 8, 1 resimden 1.

    • Position the laptop so that the bottom is facing upward.

    • Remove the three 4 mm Phillips #0 screws holding the bottom of the palm rest.

    Düzenle

  9. Dell Latitude X300 Palm Rest/Track Pad Replacement: adım 9, 1 resimden 1.

    • Return the laptop to proper position and open the screen.

    • Remove the six 4 mm Phillips #0 screws holding in the palm rest.

    Düzenle

  10. Dell Latitude X300 Palm Rest/Track Pad Replacement: adım 10, 1 resimden 1.

    • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

    • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

    Düzenle

  11. Dell Latitude X300 Palm Rest/Track Pad Replacement: adım 11, 1 resimden 1.

    • Lift up on the small ZIF connector and remove the ribbon.

    • If the ribbon seems stuck, gently wiggle it to remove. Do not pull the ribbon with great force.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

8 tane daha katılımcı ile

Thomas Wong

Üyelik tarihi: 01/20/12

23 İtibar

2 adet Kılavuz yazıldı

Rozetler: 7

+4 tane daha rozet

Ekip

Cal Poly, Team 11-20, Maness Winter 2012 Cal Poly, Team 11-20, Maness Winter 2012 üyesi

CPSU-MANESS-W12S11G20

4 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 4

Son 7 gün: 8

Son 30 gün: 17

Her zaman: 912