Parçalar

Hiçbir parçaya gerek yok.

  1. Rotate the photo printer so that the bottom of the case faces upward.
    • Rotate the photo printer so that the bottom of the case faces upward.

    Yorum Ekle

  2. Use a Phillips #2 screwdriver to remove the three 5.65 mm screws on the bottom panel of the case in a counter-clockwise fashion.
    • Use a Phillips #2 screwdriver to remove the three 5.65 mm screws on the bottom panel of the case in a counter-clockwise fashion.

    Yorum Ekle

    • Rotate the device so that it is upright again. Under the LCD Panel there is a 9.62 mm screw, unscrew using a Phillips #2 screwdriver.

    Yorum Ekle

    • Remove the back panel of the case by pulling directly back.

      • Some carefully applied force may be required to remove this part.

    Yorum Ekle

    • Rotate the photo printer so that the bottom panel faces up once again. Now lift off the bottom panel of the case to access all internal components.

    Yorum Ekle

    • Finally remove the side panel with the ink-cartridge door by holding the right side and pulling backwards with the left side.

      • Caution! The side panel is held in by tabs; don't break these.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Jonathan Mintz

Üyelik tarihi: 04-04-2012

11 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 14-7, Forte Spring 2012 Cal Poly, Team 14-7, Forte Spring 2012 üyesi

CPSU-FORTE-S12S14G7

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 501