Rotate the photo printer so that the bottom of the case faces upward.
  • Rotate the photo printer so that the bottom of the case faces upward.

Yorum Ekle

Use a Phillips #2 screwdriver to remove the three 5.65 mm screws on the bottom panel of the case in a counter-clockwise fashion.
  • Use a Phillips #2 screwdriver to remove the three 5.65 mm screws on the bottom panel of the case in a counter-clockwise fashion.

Yorum Ekle

  • Rotate the device so that it is upright again. Under the LCD Panel there is a 9.62 mm screw, unscrew using a Phillips #2 screwdriver.

Yorum Ekle

  • Remove the back panel of the case by pulling directly back.

    • Some carefully applied force may be required to remove this part.

Yorum Ekle

  • Rotate the photo printer so that the bottom panel faces up once again. Now lift off the bottom panel of the case to access all internal components.

Yorum Ekle

  • Finally remove the side panel with the ink-cartridge door by holding the right side and pulling backwards with the left side.

    • Caution! The side panel is held in by tabs; don't break these.

Yorum Ekle

  • Carefully remove the inner components of the device by lifting the inner components up and out of the casing.

Yorum Ekle

  • Locate the red and black cable that is connecting the fan to the top of the logic board.

Yorum Ekle

  • Carefully, remove the red and black cable from the logic board by pulling gently in order to isolate the cooling fan from the device.

Yorum Ekle

  • Locate the data ribbon that connects the LCD panel to the mother board.

  • Carefully unclip the ribbon from the mother board.

  • Separate top cover from bottom base and flip upright so that the LCD panel is facing up for the next step

Yorum Ekle

  • Slide the LCD panel out and away from the printer case.

  • Hold bottom of LCD panel and lift the screen 70 degrees. Set the screen face down for the next step

Yorum Ekle

  • Use a Phillips 00 screwdriver to remove the four 5.4 mm screws behind where the LCD screen is.

Yorum Ekle

  • You can now separate the individual pieces from each other, allowing the screen to be accessible to replace.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Ashley Lopez

Üyelik tarihi: 04-04-2012

1 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team 14-7, Forte Spring 2012 Cal Poly, Team 14-7, Forte Spring 2012 üyesi

CPSU-FORTE-S12S14G7

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 385