Ana içeriğe geç

Giriş

Before the majority of components can be accessed to be replaced, the back panel will need to come off.

Parçalar

Hiçbir parça belirtilmedi.

  1. Turn the laptop upside down.
    • Turn the laptop upside down.

    • Make sure the laptop is turned off.

    • Using the T5 Torx Screwdriver, remove the ten 3 mm long screws from the perimeter of the back of the laptop.

  2. Open up the information panel door (on the middle of the back side). While holding the door open, use the Phillips #00 Screwdriver to remove the two 10 mm long screws.
    • Open up the information panel door (on the middle of the back side).

    • While holding the door open, use the Phillips #00 Screwdriver to remove the two 10 mm long screws.

  3. Carefully lift 2  corners of the back panel upwards, releasing the whole panel. Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck. Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck.
    • Carefully lift 2 corners of the back panel upwards, releasing the whole panel.

    • Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck.

Sonuç

To reassemble your device, follow these instructions in reverse order.

4 farklı kişi bu kılavuzu tamamladı.

Brandon Schmidt

Üyelik tarihi: 04-10-2018

876 İtibar

3 adet Kılavuz yazıldı

Takım

UW Stout, Team S6-G1, Ogden Fall 2018 UW Stout, Team S6-G1, Ogden Fall 2018 üyesi

UWSTOUT-OGDEN-F18S6G1

4 Üyeler

5 adet Kılavuz yazıldı

0 Comments

Yorum Ekle

İstatistikleri Görüntüle:

Past 24 Hours: 9

Past 7 Days: 65

Past 30 Days: 314

Her zaman: 3,179