Eşyalarını Tamir Et Topluluk Mağaza

DigiTech RP70 DC Power Connector Replacement

Giriş

If the DC power connector is broken this guide will teach you how to remove the broken component for replacement.

Neye ihtiyacın var

  1. DigiTech RP70 DC Power Connector Replacement, Motherboard: adım 1, 2 resimden 1. DigiTech RP70 DC Power Connector Replacement, Motherboard: adım 1, 2 resimden 2.

    • Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.

    • Remove the four 8mm Phillips #0 screws located on the back panel.

    Düzenle

  2. DigiTech RP70 DC Power Connector Replacement: adım 2, 2 resimden 1. DigiTech RP70 DC Power Connector Replacement: adım 2, 2 resimden 2.

    • Remove the back panel to expose the motherboard.

    Düzenle

  4. DigiTech RP70 DC Power Connector Replacement: adım 3, 1 resimden 1.

    • Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.

    Düzenle

  5. DigiTech RP70 DC Power Connector Replacement: adım 4, 1 resimden 1.

    • Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.

    Düzenle

  6. DigiTech RP70 DC Power Connector Replacement, DC Power Connector: adım 5, 1 resimden 1.

    • Desolder the back of the motherboard where the power connector is located.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir Yorum

Later? I cant see to other

ISAAC SALAZAR - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 5

Her zaman: 313