Giriş

Whether for installing a new stereo system, or just for checking for disconnected wires, the center console of a car often needs to be removed. This guide will show you how to remove the center console of your Ford Mustang.

Parçalar

Hiçbir parçaya gerek yok.

Open the rear part of the middle console.
  • Open the rear part of the middle console.

Yorum Ekle

Grip the right side of the console and pull up towards the passenger seat to remove it.
  • Grip the right side of the console and pull up towards the passenger seat to remove it.

Yorum Ekle

  • Locate the two bolts under the air conditioning controls at the bottom of the face plate.

  • Loosen these two bolts with a basic socket wrench suited for 7mm bolts.

Yorum Ekle

  • Wedge a spudger or plastic opening tool (in place of the screwdriver shown) under the top of the face plate.

  • Apply pressure until the corners "pop" out of place.

Yorum Ekle

  • Inspect the interior of the center console for damaged wires or other faulty components.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

8 başka kişi bu kılavuzu tamamladı.

Christopher Pell

Üyelik tarihi: 26-09-2012

173 İtibar

5 adet Kılavuz yazıldı

Takım

Cal Poly, Team 15-45, Forte Fall 2012 Cal Poly, Team 15-45, Forte Fall 2012 üyesi

CPSU-FORTE-F12S15G45

5 Üyeler

6 adet Kılavuz yazıldı

4 Yorum

Were can I get that faceplate connector and the connectors for the sterio...I have a 2010 v6 mustang

Zack - Yanıt

I found a replacement but need wire configuration for the 4 wires can anyone help ?

beauxvader -

Try using the correct tool to remove panels...

hotmail1hotmail - Yanıt

The screwdriver is not required. Nor is any other tool at that point. GENTLY pull from the tabs where you removed the screws.

The faceplate will begin to loosen from the bottom up. After pulling out a few inches, push back inward about a half of an inch. This has the effect of a teeter/totter on the remaining top wedge pins. Now grasp the two knobs on the bottom of the panel (fan and temp) and loosen first the left side and then the right side. No real force required at any time and practically falls out. NO SCARS on the trim.

cheers,

dbw -

davidwest805 - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 6

Son 7 Gün: 28

Son 30 Gün: 144

Her zaman: 9,402