Giriş

This is the beginning process to remove or replace any functional component in the AirPort.

  1. Remove the three 5mm T7 Torx screws from the back panel.
    • Remove the three 5mm T7 Torx screws from the back panel.

  2. Remove one 5mm phillips screw located under the identification sticker.  You will need to remove the sticker or make a hole to get to the screw.
    • Remove one 5mm phillips screw located under the identification sticker. You will need to remove the sticker or make a hole to get to the screw.

  3. Pro Tech Toolkit içeren veya $100tüm siparişlerde ücretsiz kargo!

    Mağazamıza Göz Atın
  4. Separate the bottom and top casings.
    • Separate the bottom and top casings.

  5. Remove the metal case from the top case of the AirPort, there are no screws holding it on. Remove the four screws from the metal casing.
    • Remove the metal case from the top case of the AirPort, there are no screws holding it on.

    • Remove the four screws from the metal casing.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Michael Garcia

Üyelik tarihi: 12-10-2011

369 İtibar

5 adet Kılavuz yazıldı

Takım

Cal Poly, Team 17-15, Regan Fall 2011 Cal Poly, Team 17-15, Regan Fall 2011 üyesi

CPSU-REGAN-F11S17G15

3 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 2

Son 30 Gün: 9

Her zaman: 1,767