Giriş

Use this guide to replace a dysfunctional back cover.

Parçalar

Hiçbir parçaya gerek yok.

Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.
  • Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.

Yorum Ekle

On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.
  • On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.

  • Pry up the panel; starting from the front/bottom corner, as indicated.

    • There's a concealed lip, under the opposite edge.

Yorum Ekle

Remove the three long black screws from the bottom using a #00 Phillips screwdriver.
  • Remove the three long black screws from the bottom using a #00 Phillips screwdriver.

  • Use tweezers to lift the panel.

Yorum Ekle

Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.
  • Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Daniel Bussone

Üyelik tarihi: 28-01-2011

1.206 İtibar

11 adet Kılavuz yazıldı

Takım

Cal Poly, Team 3-41, Regan Winter 2011 Cal Poly, Team 3-41, Regan Winter 2011 üyesi

CPSU-REGAN-W11S3G41

2 Üyeler

11 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 3

Son 30 Gün: 20

Tüm Zamanlar: 3,439