Giriş

This guide will show you how to disassemble the back and side panel of the printer.

Remove the following two Phillips screws:
  • Remove the following two Phillips screws:

    • Two 7.85 mm Phillips #1 screws

Yorum Ekle

Pull the back cover off by lifting up on the cover.
  • Pull the back cover off by lifting up on the cover.

    • You may need to pull firmly as it requires quite a bit of force.

Yorum Ekle

  • Open the front tray.

Yorum Ekle

  • Lift the scanner compartment.

Yorum Ekle

  • After opening up the scanner compartment, make sure the blue lever locks into place, keeping the compartment open.

Yorum Ekle

  • Push the blue lever back while twisting it clockwise in order to remove the lever from its slot.

  • After removing the lever, close the scanner compartment and the scanner cover.

Yorum Ekle

  • Use the plastic opening tool to pry open the side cover.

Yorum Ekle

  • Flip the printer so that you are facing the underside.

  • Use the plastic opening tool to remove the corner of the side panel from the pin.

    • Plastic pin.

Yorum Ekle

  • Using the plastic opening tool, remove the side panel by loosening it from the bottom of the printer.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

5 başka kişi bu kılavuzu tamamladı.

Kevin Cole

Üyelik tarihi: 17-01-2013

98 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team 19-41, Regan Winter 2013 Cal Poly, Team 19-41, Regan Winter 2013 üyesi

CPSU-REGAN-W13S19G41

4 Üyeler

6 adet Kılavuz yazıldı

Bir Yorum

Good job!!!!

lhitvietnam - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 Gün: 19

Son 30 Gün: 79

Her zaman: 13,001