Ana içeriğe geç

Disassembling Canon PowerShot SD800 IS LCD Display

Neye ihtiyacın var

  1. Disassembling Canon PowerShot SD800 IS LCD Display, Back Cover: adım 1, 1 resimden 1.
    • Remove one 2.25mm screw on the bottom.

  2. Disassembling Canon PowerShot SD800 IS LCD Display: adım 2, 1 resimden 1.
    • Remove two 2.25mm screws on the right side looking from the front.

  3. Disassembling Canon PowerShot SD800 IS LCD Display: adım 3, 1 resimden 1.
    • Remove one 4.7mm screw on the side with the AV output.

  4. Disassembling Canon PowerShot SD800 IS LCD Display: adım 4, 1 resimden 1.
    • Pull off the back cover.

    • The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.

  5. Disassembling Canon PowerShot SD800 IS LCD Display, LCD Assembly: adım 5, 1 resimden 1.
    • Remove 2 2.4mm screws on bottom.

  6. Disassembling Canon PowerShot SD800 IS LCD Display: adım 6, 1 resimden 1.
    • Follow the small data cable to where it connects to the camera.

    • Lift the back white portion to unlock the cable.

    • The cable should easily slide out.

    • The connector is very fragile. Use caution when lifting the lock.

  7. Disassembling Canon PowerShot SD800 IS LCD Display: adım 7, 1 resimden 1.
    • Gently lift LCD display off.

    • There will be two data cables still attached to the camera. Do not break them.

    • There may be a loose strip of metal along the inner side of the LCD display for a secure fit.

  8. Disassembling Canon PowerShot SD800 IS LCD Display: adım 8, 1 resimden 1.
    • Follow the larger cable to where it connects to the camera.

    • Lift the front black portion of the connector to unlock the data cable.

    • The cable should easily slide out.

    • The connector is very fragile. Use caution when lifting the lock.

  9. Disassembling Canon PowerShot SD800 IS LCD Display, LCD Display: adım 9, 1 resimden 1.
    • Pry the LCD display out from the four metal clamps.

  10. Disassembling Canon PowerShot SD800 IS LCD Display: adım 10, 1 resimden 1.
    • To remove the LCD, peel the larger data cable off from the frame.

    • The LCD is glued by its data cable to the back of the LCD frame.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Jeremy Rabaino

Üyelik tarihi: 10/10/10

135 İtibar

6 adet Kılavuz yazıldı

Ekip

Cal Poly, Team 20-9, Maness Fall 2010 Cal Poly, Team 20-9, Maness Fall 2010 üyesi

CPSU-MANESS-F10S20G9

5 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 2

Her zaman: 2,689