Eşyalarını Tamir Et Topluluk Mağaza

Disassembling Garmin Nuvi 1200 Logic Board

Giriş

This guide shows how to fully disassemble a Garmin Nuvi 1200 to replace the logic board.

Neye ihtiyacın var

  1. Disassembling Garmin Nuvi 1200 Logic Board, Logic Board: adım 1, 1 resimden 1.

    • Remove to sticker on the back of the unit and then remove the two T5 scremws once this is done use a spudger to carefully pry off the silver cover.

    • Once the tool is inserted it can slide around the entire device.

    Düzenle

  2. Disassembling Garmin Nuvi 1200 Logic Board: adım 2, 1 resimden 1.

    • Remove four small T5 torx screws.

    • Be gentle, the screws are easily stripped.

    Düzenle

  4. Disassembling Garmin Nuvi 1200 Logic Board: adım 3, 2 resimden 1. Disassembling Garmin Nuvi 1200 Logic Board: adım 3, 2 resimden 2.

    • Lift cover off of unit.

    • Be careful not to lose small rubber piece on the bottom right corner.

    Düzenle

  5. Disassembling Garmin Nuvi 1200 Logic Board: adım 4, 1 resimden 1.

    • Disconnect ribbon cable from logic board.

    Düzenle

  6. Disassembling Garmin Nuvi 1200 Logic Board: adım 5, 1 resimden 1.

    • Remove two T5 torx screws holding down logic board.

    • Disconnect battery.

    Düzenle

  7. Disassembling Garmin Nuvi 1200 Logic Board: adım 6, 1 resimden 1.

    • Gently lift the logic board out of the unit

    • Be careful not to damage the battery connector on the top of the unit.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

6 farklı kişi bu kılavuzu tamamladı.

Yazar

1 tane daha katılımcı ile

Zachary Landau

Üyelik tarihi: 11/28/10

206 İtibar

1 Kılavuz yazıldı

Rozetler: 8

+5 tane daha rozet

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 2

Her zaman: 5,223