Giriş

In order to gain access to most of the internal components the top (or lid) of the printer must be removed. This guide is intended as a prerequisite for other installations.

Parçalar

Hiçbir parçaya gerek yok.

Open the front access panel by placing your finger in the front slot and pulling gently.
  • Open the front access panel by placing your finger in the front slot and pulling gently.

Yorum Ekle

Open the protective lid that is covering the glass. Press gently against the base of the panel to remove the lid from the rest of the printer.
  • Open the protective lid that is covering the glass. Press gently against the base of the panel to remove the lid from the rest of the printer.

Yorum Ekle

Remove the four 9mm T10 Torx screws on the top. Remove the four 9mm T10 Torx screws on the top. Remove the four 9mm T10 Torx screws on the top.
  • Remove the four 9mm T10 Torx screws on the top.

Yorum Ekle

Carefully lift the top panel off of the printer. Do not tear or damage the two cables that connect the top lid to the motherboard.
  • Carefully lift the top panel off of the printer.

  • Do not tear or damage the two cables that connect the top lid to the motherboard.

Yorum Ekle

Remove the two cables by gripping each one close to their connection ports on the motherboard and gently disconnecting them. Remove the two cables by gripping each one close to their connection ports on the motherboard and gently disconnecting them. Remove the two cables by gripping each one close to their connection ports on the motherboard and gently disconnecting them.
  • Remove the two cables by gripping each one close to their connection ports on the motherboard and gently disconnecting them.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

16 başka kişi bu kılavuzu tamamladı.

Tim

Üyelik tarihi: 15-01-2013

134 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 18-35, Regan Winter 2013 Cal Poly, Team 18-35, Regan Winter 2013 üyesi

CPSU-REGAN-W13S18G35

5 Üyeler

8 adet Kılavuz yazıldı

Bir Yorum

I want fix my HP DESKJET F448o, My problem is, that the scanner arm is block.

When I turn on, the scanner arm is block, how can fix its?

mbeto0351 - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 Gün: 23

Son 30 Gün: 83

Her zaman: 5,980