Giriş

In order to replace the RAM, hard drive, or wireless card in the laptop you must first remove the back panel, as shown in this guide.

Parçalar

Hiçbir parçaya gerek yok.

  1. Working on your device while it is turned on may result in electric shock. Make sure to shut down and unplug your device before you begin.
    • Working on your device while it is turned on may result in electric shock. Make sure to shut down and unplug your device before you begin.

    • Flip your device over so the bottom panel is facing up.

  2. Slide the lock switch below the bottom right of the battery to the left.
    • Slide the lock switch below the bottom right of the battery to the left.

    • The battery is held in by a latch in the front and tabs in the back.

    • Lift up the battery, rotating it up and away from you, then pull it out.

    • To put the battery back in, line it up with the battery bay and the holes for the tabs. Then let the battery rotate towards you and press down until the latch engages and you hear a click.

  3. Pro Tech Toolkit içeren veya $100,00tüm siparişlerde ücretsiz kargo!

    Mağazamıza Göz Atın
  4. Unscrew one Phillips #1 screw from the back panel.
    • Unscrew one Phillips #1 screw from the back panel.

    • The screw is on a spring and attached to the panel. It will pop up, but will not separate from the back panel.

  5. Slide the back panel down and pull it up. Slide the back panel down and pull it up.
    • Slide the back panel down and pull it up.

Sonuç

To reassemble your device, follow these instructions in reverse order.

5 başka kişi bu kılavuzu tamamladı.

John Sutton

Üyelik tarihi: 24-04-2014

1.406 İtibar

8 adet Kılavuz yazıldı

Takım

Cal Poly, Team 11-51, Amido Spring 2014 Cal Poly, Team 11-51, Amido Spring 2014 üyesi

CPSU-AMIDO-S14S11G51

4 Üyeler

12 adet Kılavuz yazıldı

0 Yorum

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 4

Son 30 Gün: 24

Her zaman: 2,065