Giriş

Prerequisite: Battery, Uppercase removed

  1. Flip the ThinkPad over so that it is upside down.
    • Flip the ThinkPad over so that it is upside down.

    • Slide the highlighted tab to the left.

    • With your finger on the tab, remove the battery by lifting it upwards away from the laptop.

    Yorum Ekle

  2. Remove the highlighted screw with a Phillips #1 screwdriver.
    • Remove the highlighted screw with a Phillips #1 screwdriver.

    • Pull the hard drive out.

    Yorum Ekle

    • Make sure the laptop is upside down and oriented in the direction shown.

    • Remove the six 16.7mm screws inside the circled holes.

    Yorum Ekle

    • Rotate the ThinkPad so that the hard drive bay is facing you.

    • Remove the black cover to reveal a 14.8mm screw.

    • Remove the uncovered screw with a Phillips #0 screwdriver.

    Yorum Ekle

    • Flip the ThinkPad over and open the LCD panel.

    • Pry apart the keyboard with a plastic opening tool or with your fingers.

    Yorum Ekle

  3. Free shipping on orders over $20
    Use code BLUEANDBLACK at checkout
    Free shipping on orders over $20
    Use code BLUEANDBLACK
    • Be careful not to pull out the keyboard carelessly; there is a connector underneath it!

    • Lift the front end of the keyboard as shown.

    • Using your fingers, remove the black film cover.

    Yorum Ekle

    • Locate the connector attached to the motherboard.

    • Disconnect the ribbon cable by removing the connector.

    Yorum Ekle

    • Lift and remove the keyboard.

    • Remove the two 5.6mm screws.

    • Remove the 16.7mm screw.

    Yorum Ekle

    • You will need to use a little force. Be wary of the tabs.

    • Pry off the upper case with your hands.

    Yorum Ekle

    • Remove the 5.6mm screw that holds the LCD to the upper case.

    Yorum Ekle

    • Remove the 5.6mm screw on the left side of the three-pronged connector.

    • Remove the other two 16.7mm screws.

    • Lift and remove connector.

    Yorum Ekle

    • Pull out the white tab connecting the LCD to the motherboard.

    Yorum Ekle

    • Turn the laptop so that the back is facing you.

    • Remove the four 5.6mm long screws.

    Yorum Ekle

    • Place the laptop so that the LCD is facing you again.

    • Gently lift the LCD monitor up and out.

    • Remove the black plastic tab.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Jessica

Üyelik tarihi: 06-10-2010

159 İtibar

7 adet Kılavuz yazıldı

Takım

Cal Poly, Team 4-44, Amido Fall 2010 Cal Poly, Team 4-44, Amido Fall 2010 üyesi

CPSU-AMIDO-F10S4G44

4 Üyeler

26 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 3

Son 7 Gün: 4

Son 30 Gün: 11

Her zaman: 3,084