Giriş

With this guide you can take your MM-4 from one solid brick of a speaker to four parts and a bunch of screws. This is useful if you are replacing a bad driver, or if the connector becomes damaged and you need to replace it.

Turn the speaker face down, so the connector side is up. Remove the four #2 Philips screws on the back plate.
  • Turn the speaker face down, so the connector side is up.

  • Remove the four #2 Philips screws on the back plate.

Yorum Ekle

Remove the foam insert to expose the two spade connectors.
  • Remove the foam insert to expose the two spade connectors.

  • Carefully separate the connectors

Yorum Ekle

Turn the speaker so the grill side is up. Remove the four screws on the grill.  I had to use a t-10 Torx bit to remove them.
  • Turn the speaker so the grill side is up.

  • Remove the four screws on the grill. I had to use a t-10 Torx bit to remove them.

  • The grill is not glued on, but may require a bit of prying to remove.

Yorum Ekle

Remove the four silver bolts holding the speaker in place.  These bolts also have threads inset for the grill screws to fit into. This is a pretty quick and easy teardown, not too many parts in this one.  The meyer speaker's part number is ST-164.  It's a 16 Ohm driver.
  • Remove the four silver bolts holding the speaker in place. These bolts also have threads inset for the grill screws to fit into.

  • This is a pretty quick and easy teardown, not too many parts in this one. The meyer speaker's part number is ST-164. It's a 16 Ohm driver.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

RoggeSound

Üyelik tarihi: 05-06-2010

2.007 İtibar

1 Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 5

Son 30 Gün: 22

Her zaman: 5,487