Eşyalarını Tamir Et Topluluk Mağaza

Disassembling Nano 7/LINK (D-P Serial)

Giriş

Removing the panelwork on any Kaffelogic Nano or Nucleus Link coffee roaster with a D or P prefix serial number.

Neye ihtiyacın var

  1. Disassembling Nano 7/LINK (D-P Serial), Removing Front Panel Screws: adım 1, 2 resimden 1. Disassembling Nano 7/LINK (D-P Serial), Removing Front Panel Screws: adım 1, 2 resimden 2.

    • Remove the 6x 2.5mm Hex screws on the left and right side of the roaster.

    • Take care not to damage the buttons while maneuvering the front panel, with all six screws removed it may fall away.

    Düzenle

  2. Disassembling Nano 7/LINK (D-P Serial), Lift the closure: adım 2, 2 resimden 1. Disassembling Nano 7/LINK (D-P Serial), Lift the closure: adım 2, 2 resimden 2.

    • Hold the front panel steady while removing the plastic top/closure.

    Düzenle

  4. Disassembling Nano 7/LINK (D-P Serial), Removing the front panel: adım 3, 1 resimden 1.

    • Pull away the front panel carefully.

    Düzenle

  5. Disassembling Nano 7/LINK (D-P Serial), Removing the rear panel: adım 4, 3 resimden 1. Disassembling Nano 7/LINK (D-P Serial), Removing the rear panel: adım 4, 3 resimden 2. Disassembling Nano 7/LINK (D-P Serial), Removing the rear panel: adım 4, 3 resimden 3.

    • Remove the last 2.5mm Hex screw securing the rear panel.

    • Pull up on the rear panel to remove it from the roaster.

    Düzenle

  6. Disassembling Nano 7/LINK (D-P Serial), Access granted: adım 5, 2 resimden 1. Disassembling Nano 7/LINK (D-P Serial), Access granted: adım 5, 2 resimden 2.

    • Set the panels aside somewhere safe and bask in the beauty of your naked roaster.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

1 tane daha katılımcı ile

Kaffelogic

Üyelik tarihi: 07/23/25

2.098 İtibar

18 adet Kılavuz yazıldı

Rozetler: 5

+2 tane daha rozet

0Kılavuz Yorumları

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 1

Son 30 gün: 4

Her zaman: 50