Ana içeriğe geç

Giriş

Use this guide to remove the cover from your Optoma HD20.

Parçalar

Hiçbir parça belirtilmedi.

  1. Twist focal cap clockwise until it is fully extended. Remove focal cap by pulling it straight out.
    • Twist focal cap clockwise until it is fully extended.

    • Remove focal cap by pulling it straight out.

  2. Use a Phillips #1 screwdriver to remove the three 7.5mm screws on the bottom of the device.
    • Use a Phillips #1 screwdriver to remove the three 7.5mm screws on the bottom of the device.

  3. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  4. Use a plastic opening tool to gently pry the top cover off of the device.
    • Use a plastic opening tool to gently pry the top cover off of the device.

    • It is easier to pry off the cover from the back side just above the HDMI ports.

  5. When removing the cover, be cautious of the ribbon connecting the top buttons to the main circuit board. The ribbon must be disconnected before proceeding.
    • When removing the cover, be cautious of the ribbon connecting the top buttons to the main circuit board. The ribbon must be disconnected before proceeding.

    • Remove the ribbon by disconnecting it from the main circuit board.

    • Lift up the clip holding it down and pull the ribbon out.

Sonuç

To reassemble your device, follow these instructions in reverse order.

5 farklı kişi bu kılavuzu tamamladı.

Trever

Üyelik tarihi: 22-01-2015

1.052 İtibar

6 adet Kılavuz yazıldı

Takım

Cal Poly, Team 21-23, Maness Winter 2015 Cal Poly, Team 21-23, Maness Winter 2015 üyesi

CPSU-MANESS-W15S21G23

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 4

Son 30 Gün: 17

Her zaman: 1,604